Totseans

Tag: Mini spraypaint cans

  • How to Refill Mini Spraypaint Cans

    TheWitchDoctor is not responsible for anything you do with this guide besides reading it and all that shit.

    Mini spraypaint cans, they’re good because of their small size and they’re bad because of their small size. They work great for indoor hits and high profile spots, the downside being that you’ll only get a couple of tags out of them. Don’t toss them out though, this guide will show you how to reuse them for another day of fun on the streets.

    You will need:

    • A mini/pocket spraypaint can
    • A donor can WITH A MALE VALVE

    Male Female Spraycans

    Male valve:

    Male Spraycan Valve

     

    Step one:

    Shake the male can really good. Shake it better than wires shook that one baby.

    Step two:

    Connect the cans with the male donor can on bottom, like so:

    Male Female Spraypaint Can Sex

    Step three: Push down hard so the paint flows into the small can until the pressure equalizes.

    Discuss

    How to Refill Mini Spraypaint Cans by DarthBeaver

  • Getting Through A Fence

    Getting Through A Fence

    When trying to enter or exit areas, a fence may be in your way. Here are several ways to get past it.

    Climb over the fence

    This works best if the fence does not have barbed wire on top. Simply climb over, or jump over if it’s low enough, and you’re through. If there are tools nearby such as ladders or crates, use them if wanted.

    If there is barbed wire, it can get tricky. There are several scenarios here:

    • Straight lines of barbed wire, noncontinuous due to a change in elevation. Find the break and climb over from there. The higher point will offer support in climbing over the lower point.
    • Straight lines of barbed wire, continuous, no height change. Find the supports for the barbed wire, use them to assist you and prevent falling. Avoid touching the barbed wire.
    • Angled barbed wire. This is tough, but the same method as #2 can be applied, but use much more care. Avoid at all costs.
    • Looped razor wire. Do not attempt to climb over this. More on this later.

    CAUTION: Take extreme care when climbing over barbed wire. Cuts can lead to infections. Tetanus is also not fun.

    Cut through the fence

    Use wire cutters to cut through a chain link fence, or a tool like an axe or sledgehammer to smash through wooden fences. This leaves obvious marks of unauthorized entry, so take care. You can try to put it back into place to hide the damage, but it will be discovered eventually.

    Bypass barbed wire/razor wire

    Couple ways to do this:

    • Use wire cutters to cut through. This leaves obvious marks of unauthorized entry.
    • Drape a thick cloth, like a rug over the wire and climb over.

    Electric Fences

    Avoid these unless you’re wearing a rubber suit. If you can find a switch to turn it off or find a way to disconnect it, proceed as you would with a normal fence.

    Methods less used

    • Drive through the fence with a car
    • Explosives
    • Fly over in a plane/helicopter
    • Parachute
    • Springboard
    • Dig underneath

    Now that you’ve gotten to the other side of the fence, take care to watch out for any other security features the location might have. Also make sure that you have a way to get back across the fence or have another exit strategy planned.