Blowgun
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
Blowgun
In this article we will attemt to explain the use and manufacture of a powerful blow-gun and making darts for the gun.
The possestion of the blow gun described in this article IS a felony. So be carefull where you use it. I dont want to get you all busted.
Needed:
1. Several strands of yarn (About 2 inches a piece)
2. A regular pencil
3. A 2 1/4 inch long needle, hopefully with a beaded head. If not obtainable, wrap tape around end of needle.
4. 2-3 1/4 foot pipe. (PVC or Aluminum) Half a inch in diameter
Constructing the dart.
1st- Carefully twist and pull the metal part (Along with eraser) of the pencil till it comes off.
2nd- Take Pin and start putting about 5-7 Strands of yarn on the pin. Then
push them up to the top of the pin. But not over the head of the pin (or the tape).
3rd- Push pin through the hollow part of the head where the pencil was before.
4th- That should for a nice looking dart. (see illustration)
####\
#####>>>>>-----
####/
# is the yarn
> is the head of the pencil
- is the pin it-self
Using the Darts
1st- Now take the finished dart and insert it in the tube (if it is too small put on more yarn.)
2nd- Aim the tube at a door, wall, sister, ect.
3rd- blow on the end of the pipe.
4th- Sometimes the end of the pipe may be sharp. When this happens I suggest you wrap it with some black electrician tape.It should feel a lot better.
|