|
NIA #33
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
???????????????????? ????????????????????????????????? ????????????????????
? Founded By: ? ? Network Information Access ? ? Mother Earth BBS ?
? Guardian Of Time ??? 04JUN90 ??? NUP:> DECnet ?
? Judge Dredd ? ? Judge Dredd ? ?Text File Archives?
???????????????????? ? File 33 ? ????????????????????
? ????????????????????????????????? ?
? ??????????????????????? ?
?????????????????? UK Telephone System ??????????????????
???????????????????????
Telephone services in the UK are provided by the following
organizations:
British Telecom
Mercury Communications
Hull Telephone Company
Vodaphone
Cellnet
For historical reasons, BT allocates area codes. This will change in a
couple year's time.
The bottom level of the BT system is the "Junction Exchange" (JX in
this document). A JX is a unit which handles 10,000 subscriber
numbers, numbered 0000 to 9999. A number may have several lines
attached to it (hundreds in some cases). These four digit numbers are
called LNs (Line Numbers) in this document.
In a few rural areas, some subscriber numbers are three digits. The
appropriate JX thus takes some LNs as being three digits, and some
(possibly none) as four. Such JXs are being phased out. [This should
be distinguished from the case where all LNs in a group of ten go to
the same subscriber, and are interconnected. For example, Basildon
hospital officially has the LN 2811. In fact, all of LNs 2800-2899 go
to the hospital switchboard, and the JX will route the call as soon as
it sees "28".]
JXs are grouped into "Area Codes" (AC). Each JX has a one or two digit
number within its AC - one digit numbers are being phased out. The
exception is in "all-figure areas", where each JX has a three digit
number. These numbers do not begin with 0 or 1.
Each area code has a number. For most area codes, this is three
digits, but for all-figure areas, it is two digits.
The "number-space" for area codes is used as follows. All normal area
codes begin with a digit from 2-9. The area codes for the all-figure
areas are:
Birmingham 21
Edinburgh 31
Glasgow 41
Liverpool 51
Manchester 61
London inner 71 (new)
London outer 81 (new)
Tyne & Wear 91
Of the 720 three-digit codes, about 600-650 are in use (I do have a
complete table in numerical order, but it's not in machine-readable
form). Certain codes have special meanings:
345 Calls charged at L rate irrespective of distance
482 Hull Telephone Company
800 Free calls
831 Vodaphone
836 Vodaphone
839 Calls charged at m rate irrespective of distance
860 Cellnet
898 Calls charged at m rate irrespective of distance
Mercury has been allocated fifteen JXs in the 71 AC and the same
fifteen in the 81 AC. I believe that all Mercury subscribers have
numbers in this AC, irrespective of location.
Area code 1 was used for London (both inner and outer) until 0001 on 6th May
1990; I am unaware of any plans for it. Area code 10 is obscured by the
international access code. No area codes begin with 0 (but see below).
From any BT subscriber, you can call any number by:
0 + area code + JX number + line number
For example, anyone can call me by 0-954-78-0223. In addition, there are
certain special codes:
010 international access
0001 equivalent to 010 350 1 [Dublin]
0055 from London only; calls charged at L rate
0066 from London only; calls charged at a rate
0077 from London only; calls charged at m rate
Service codes begin with a 1:
100 operator
144 BT credit-card calls
151 fault reporting
153 international directory
155 international operator
192 directory
Area codes are further grouped into "Charging Areas" (CA). For example:
London CA: 71, 81
Cambridge CA: 220, 223
Madingley CA: 954
The exception is the Tyne and Wear AC, which is three CAs (JXs [24]??,
JXs 3??, and JXs 5??). This AC replaced three separate ACs (whose
numbers I have forgotten), each of which had its own CA.
BT has five charging rates for UK calls, and seven for international.
The UK rates, in increasing order of cost, are L, a, b1, b, and m (m
is more expensive than I, which is the cheapest international rate).
Rates also vary by time:
peak = M-F 0900-1300
standard = M-F 0800-0900 and 1300-1800
cheap = all other times
(these do not apply to international calls).
All calls within a CA are at rate L, as are those to "neighbouring"
CAs. Each CA has a nominal centre. For all other calls, if the CA
centres are within 56km, the call is at rate a, and otherwise it is at
rate b. Rate b1 replaces rate b where BT feels under pressure from
Mercury (London CA to Cambridge CA is b1, but to Madingley CA is b).
Rate m ("mobile") is only used for calls to Vodaphone, Cellnet, and
the special area codes. Hull is treated as a normal CA. Calls from BT
to Mercury are charged as normal calls to the London CA.
The real complications (you thought this wasn't enough ?) come when
dialling calls other than by the full 0+ sequence. For this you need
to know the subscriber number (SN).
The one simple case is the all-figure areas. For each area, lines
within the area are identified by seven digits (JX+LN), and calls are
made by just dialling this number [in Tyne and Wear, calls *between*
ACs must be prefixed with 90; this is being phased out].
Everywhere else, we run into the "Named Exchange" (NE). An NE
comprises a set of JXs, usually, but not always, in the same AC. A
subscriber is identified by an exchange name followed by the SN, which
is the LN with a prefix. The prefix can be empty, the last digit of a
two digit JX, or the JX number. A catch to beware of is that sometimes
two NEs have the same name but are distinguished by number length. For
example, there is "Welwyn (six figure numbers)" and "Welwyn (four
figure numbers)". These cover the same geographical area, but may have
different ACs (these two don't). They are always in the same CA.
As an example, the Madingley CA consists of:
AC JX NE Prefix
954 78 Crafts Hill 78
954 21 Madingley 21
954 3 Swavesey 3
954 6 Willingham 6
954 5 Cottenham 5
954 4 Caxton (4 digits) none
954 71 Caxton (6 digits) 71
954 7 Elsworth none
Calls to CAs other than at rate L are always dialled by the full 0+
method. To call a subscriber on the same NE, it is just necessary to
dial the SN. Other calls within the CA, and to CAs which are at the L
rate, may have an alternate dialling method (not necessarily:
Madingley to Huntingdon is rate L, but 0+ must be used; all calls from
AC 71 or 81 to any other (or each other) must be dialled as 0+).
Two alternate methods seem to be in common use: the "fan" method and
the "slave" method (my names).
The "fan" method is used at the main NE of a CA. Several prefixes in
its AC are not used, but instead become dialling codes from the NE.
For example, from Cambridge:
8 -> AC 220 (same CA)
91 -> AC 440 (different CA)
92 -> AC 767 (different CA)
93 -> AC 954 (different CA)
94 -> AC 638 (different CA)
95 -> AC 763 (different CA)
96 -> AC 799 (different CA)
98 -> AC 353 (different CA)
These are then followed by the JX and LN. All other NEs in the same AC
(not the same CA) can be called by dialling the JX and LN with no
prefix (there are no cases of this in AC 223).
[Amusing side-note. Someone blew it in specifying 8 -> AC 220. The JXs
that were in AC 220 (21, 23, 24, 26, 27, 29, 5) did not occur in
AC223. So there was actually no need for the dialling code. All of
these except the last two have now been moved to Cambridge NE (and AC
223) by simply changing the SN, without changing the JX+LN
combination. The others will come soon (I have already seen people
using "Cambridge 29xxxx" phone numbers).]
The "slave" method is used at all other NEs in the same CA, and
possibly in other CAs (All of Madingley CA is a slave of Cambridge NE
in this sense). Calls to the master NE are made by dialling a single
9 followed by the SN. All calls which are rate L, and which could be
made from the master NE with a dialling code, are made by dialling 9
followed by the sequence from the master NE.
For example, from ACs 220 and 954, the following dialling codes exist:
9 -> AC 223
9+8 -> AC 220 (also used from Teversham (220 5) to West Wratting (220 29))
9+91 -> AC 440 (not available from AC 954)
9+92 -> AC 767
9+93 -> AC 954 (also see below)
9+94 -> AC 638 (not available from AC 954)
9+95 -> AC 763 (not available from AC 954)
9+96 -> AC 799 (not available from AC 954)
9+98 -> AC 353
In addition, a slave NE may also have other dialling codes not
beginning with a 9. For example, in AC 954, to dial from Caxton (six
digits), Cottenham, Crafts Hill, Madingley, Swavesey, and Willingham
to any number in the AC is done by JX+LN, without any code. On the
other hand, to dial from Elsworth to Caxton (four digits), or vice
versa, the route via Cambridge must be used (i.e. 9+93+JX+LN).
One final note. Slave exchanges have operator service provided by the
master exchange. This means that emergency service is "9+99". On
master exchanges, it is thus simply "99" (! for UK readers).
-JUDGE DREDD/NIA
|
|
